Roof Rafter Joints

A collar tie is a horizontal roof rafter compression connector that is located in the uppermost third of the span of a pair of opposed sloped or gable roof rafters.

Roof rafter joints.

The head of the rafter is joint to king post by mortise and tenon joint. But here it will be different since the hip rafter doesn t lie at 45 degrees to the commons. Rafters are the building components that run diagonally from the wall plate to the apex of a roof structure. Unit run of the hip.

Due to the width. If you are framing a cathedral ceiling there are a couple ways to deal with the need for rafter ties. They join at the peak of the roof by connecting to the opposing rafter or to a ridge beam that runs the length of the peak of the house or shed. The principal rafter is jointed to the tie beam by a bridle joint.

Possibly the most satisfiying part of the roof yet. Rafters are beams that run from the peak of the roof to the top plate of the supporting walls. At the top where the rafters meet they are either angled to meet at a point or attached to a horizontal ridge beam. In a hip roof with equal pitches the unit run of a hip or valley rafter is 17 inches for every 12 inches of run in the main roof.

Rafters form the foundation for attachment of the roof boards onto which the final roof covering is fixed. Rafters are installed piece by piece during the construction of the roof. In traditional timber they are nominally 2 inches thick and typically 8 to 10 inches wide. Each beam is notched at the bottom called a birdsmouth so that it rests flat on top of each wall.

The joint is further strengthened by a wrought iron strap. A common rafter comprises two beams that extend upwards from the top plate of either side of a shed wall. Definition of collar tie in roof framing. Measure the rafter overhang.

Birdsmouth joints cut into roofing rafters and mounted in place on top of the wall plate. The standard size of this rafter is 10 x 15 cm but it varies in using. By upper third here we mean one third of the length of the rafter from ridge to top plate. Slide the framing square until the 6 in 15 cm mark intersects the line you ve marked for the birdsmouth cut.

If is wasn t for this joint a rafter or roofing joist would only balance on top of the wall plate making fixing difficult not to mention the fact that there wouldn t be any solid connection between the roof and the supporting walls below. Rafter ties or ceiling joists acting as rafter ties are required by code unless the house is designed so that the walls or a structural ridge beam carries the full load of the roof.